Thrustmaster TWCS - Throttle for Windows

Product Information

Therefore, read the Keyboard section but instead of F2 or F3 use the buttons mapped to throttle increase and decrease on your controller. You can enlarge the deadband by increasing the value above the "Set From Throttle" button. Currently, this is 0.05 - set it as required, which will move the green lines down/up. Congratulations! You have successfully calibrated your throttle! Honeycomb Bravo Throttle Quadrant Honeycomb Bravo Throttle Quadrant Set Independent Axis to ON if you have two throttle levers. If you only have one throttle lever, set it to OFF. If you have done a previous calibration or if you have trouble with the calibration, you can reset the calibration to its default values by pressing the reset button.

If this is not the case, you can find out which controller axis is used by your controller by using the Sensitivity dialog and moving the lever to see which axis is moving. Before you change anything in the controller profile, make sure to create a dedicated controller profile for the FlyByWire A32NX in Microsoft Flight Simulator so that any changes to the throttle configuration does not impact any other aircraft. How to Create a New Controller Profile With the default throttle configuration built into the A32NX, this results in the following number of steps: This makes configuration a bit awkward because Microsoft Flight Simulator is incapable to directly use this setup for a realistic reverser functionality.Do not change the deadband if not necessary and also never set a value too large as deadband ranges must not overlap! 4. Start With Full Reverser (or Idle) Tension screw (accessible via underside of throttle’s base): adjust the S.M.A.R.T mechanism’s resistance to suit your taste

The step size for F2 and F3 is 0.05. This results in 40 steps in total from Full Reverse to TO/GA. The CLB detent is right in the middle at 20 steps. S.M.A.R.T technology: unique system of slide rails for perfectly smooth throttle sliding motion – precise and comfortable, with 3.2 inch/80 mm range of travelYou can use these default values for the Bravo throttle. See Manual Configuration on how to do this. Set Reverser on Axis to ON if your throttle has a range for the reverser thrust (lowest setting is full reverse). Microsoft Flight Simulator allows the mapping of a key or button to use the normal throttle axis as the reverser axis. To configure this, choose a key or button on your controller and map it like this: Set Reverser on Axis to OFF if your throttle does not have a range for the reverser thrust (lowest setting is idle).