UPol DOLPHIN GLAZE PUTTY

Product Information

Records the default button state of the corresponding category & the status of CCPA. It works only in coordination with the primary cookie.

After filling and rubbing body filler, you may have various imperfections left. These can range from pinholes, scratches, and even paint edges.Using the guidelines above, you can expect to rub your filler after 20 minutes. It’s recommended not to use more or less hardener, it speeds up the process but can also result in defects later on. Rubbing To prep the panel ready to accept glaze, all you need to do is rub it with paper between 80 – 180 grit. It’s up to you whether you want to remove the paint completely or apply the glaze over scuffed paint. Using and mixing glaze with plastic fillers and aluminum fillers will make them much easier to apply and rub, you should definitely try it.

It’s recommended to use 2% hardener with this glaze. Evercoat recommends adding a “ribbon” of hardener from edge to edge, as this works out to roughly 2%. After you’ve sanded the area, U-Pol suggests using a degreaser to clean the panel. I can tell you from experience that using air to blow dust and debris from the panel also works. Application I’m most familiar with Dolphin glaze and use it all the time, that’s why I recommend that over any other. U-Pol Dolphin GlazeIf you’re applying it to anything else, all you need to do is key the surface with P180 paper before applying.

Dolphin Glaze is multifunctional and can be applied to bare steel, aluminum, galvanized steel, original paint, Body filler & GRP. The technical data sheet for dolphin says that you should sand bare steel with P80 paper before applying glaze. The fact it’s self-leveling also helps a lot, as you’ll not have to spend time rubbing down high edges or lines. When To Use Dolphin Glaze Putting a final “skim coat” on top of your repair will completely change the quality of your repair. I’ve had painters thank me for this in some workplaces. Dolphin glaze is “pinhole resistant” and will help to fill any pinholes and minor scratches before sending it to paint.Free Delivery is not available for Over-Sized parcels, such as Exhausts, Radiators & Headlamps - For details on these items please see the 'Oversized Items' section below. For the initial rub it’s recommended that you use 180 paper before finishing off with 240. This is more than enough if you’ve done a light skim to fix imperfections. Mixing dolphin glaze into other fillers will help to thin out the filler and make it easier to spread. Dolphin Glaze is a premium finishing glaze that’s designed to eliminate pinholes and other surface imperfections prior to painting.