Kit Repair Porcelain - PORC-a-FILLER - Porcelain Chip Filler

Product Information

Sponge Machines & Ancillaries We supply a range of indoor & outdoor sponge machines from Refina & Berta which are suitable for cleaning epoxy & cement grouts such as UltraScape Flowpoint from quarry tiles, external paving slabs, natural stone and granite setts. Our range of sponge machines protects the joints between paving slabs by avoiding washing away the cement, whilst the machine removes the need for individuals to wash away grout on their hands and knees.

Paving, Pointing & Grouting We offer a range of pointing and grouting materials for jointing your patio slabs, outdoor paving or driveway including flowable slurry grouts such as UltraScape Flowpoint, brush-in grouts like EasyJoint and gun injected mortar for fine pointing. As well as supplying paving primer, sealants and paving and driveway cleaners. It is a complete set that takes care of almost everything. Mixing the formulas to get the perfect color takes a few minutes, and the instructions were pretty clear. After using it for ceramic tile chips, the formula delivered a beautiful result that, honestly, was surprising for us. Zero Waste – Opened tubs of EASYJoint, if not fully used, can be kept for later use providing they are covered by a minimum of 2″ (50mm) or more of water Sand the edges for a tighter fit needed. Fill in any remaining gaps with PC-11 and let the entire piece fully cure again before a final sanding. The restored piece is now ready for coloring. Wipe all surfaces with a 91% alcohol solution to remove dust and oils prior to applying filler epoxy. Mix equal parts of PC-11 epoxy filler (8).Ideal for use with natural stone, limestone, porcelain, Yorkstone, Indian Stone, granite setts and concrete paving slabs Apply. Apply an appropriate amount of the mixed epoxy adhesive to the chip in the sink (so as not to produce too much excess) and press the broken piece into it, ensuring a good fit, until it stays held in place. two steps, first mending the broken pieces and second, filling and sanding the visible break lines, chips, and gaps using the best commercially available materials. This basic process applies only to non-porous or slightly porous materials such as It is also worth pointing out that because dirty surface water can drain through the joint, over time it will result in a visual change to the EASYJoint colour. This is entirely natural; it is not a fault and it will not impair the integrity of the product.

Once the surface is clean, use tape to isolate the chip. Masking tape works too, but whatever you use, press it tightly to keep it from moving. 2. Application You never know when an accident might cause chips on any of these surfaces, and having a versatile kit might help us save. 2. The Right ColorCut. Using a crafting knife, cut an amount of the epoxy putty in the size of the chip in your sink.