Osmo Decking Oil 2.5L - Black - 020

Product Information

It would need a little bit of experimentation first to get the right result, it may be that you only require a very small amount of the coloured oil added to the clear, it is vital to thoroughly mix them together. So small ratio measures first and tests on your wood, until you get the desired result and then you are able to mix up a larger quantity in the same ratio to complete the project. This will help you to control the colour a bit more for getting the lighter result. Rosewood: 4-6 weeks exposure. However, Natural Oil Woodstain 727 Rosewood is optically suitable and requires a weathering period of approx. 12 weeks before use of Natural Oil Woodstain. An oil soaks into the surface of the wood and will wear away over time. A stain, paint or varnish is a surface sealer and over time could peel and flake, exposing bare wood underneath. Paint, stains or varnishes can be removed with a stripper such as Paint Panther Paint and Varnish Remover. Oils unfortunately can not and if you can’t wait for them to wear away naturally the you can use a pressure washer to remove much of it, care must be taken not to damage the wood however.

Before you begin, you will want to ensure that the pigments have been properly mixed in, so give the oil a good stir. If possible, and if the wood is absorbent please apply the first coat to all sides before installation. Due to their surface properties, ribbed or grooved as well as rough (sawn) wood surfaces absorb more product per square metre than smooth surfaces.

Alternative decking treatments

Thoroughly clean or lightly sand old microporous stains or completely remove old varnishes before application. If any sanding works are carried out some fresh wood species must be weathered as directed above to improve absorbency once more. Sanding to finishing grades of no more than a P120 grit are recommended. Always wear a dust mask when sanding.

After the weathering period, it is generally recommended to clean the surface from the extractive content. Osmo Wood Reviver Power-Gel can be used to refresh the colour of the wood. If necessary and before application, de-grease the dried surface with Osmo Brush Cleaner and Thinner (degreaser), always trial apply! This is a protective water-repellent coating. If your timber isn't treated with a preservative then depending on the type of wood and product, you may want to use our Wood Preserver ++ first.

Also Recommended

Balau: 12 weeks exposure. 006 Bangkirai is optically suitable and a very popular choice of colour tone.

Many wood species contain water-soluble coloured extractives ( eg Larch ) which may leach out naturally when weathered. Weathered, bare wood surfaces can be refreshed with Osmo Wood Reviver Power-gel. My advice would be to leave the floor treatment free as you are putting vinyl down. As it is an internal area preservative are not really recommended or required. Its not wise to apply an oil and then cover it with any floor covering the wood does not require protection. Ipe: 6-8 weeks exposure. 006 Bangkirai is optically suitable and a very popular choice of colour tone. Non-water based oils penetrate into the wood fibre and protect the material from water damage and other elements. Non-water based oils provide similar protection to water based oils and but require a longer drying time between coats. However, these oils generally turn the timber a darker shade of colour, similar to wet wood. Two examples we recommend are CUTEK ® CD-50 and Intergrain Natures Timber Oil.I am sorry for the delay in response, it is a super busy time here at Wood Finishes Direct. A stain or paint is a surface sealer and is likely to, over time, peel and flake, if the treatment appears to be lifting it is likely that this is the finish you have and this can be removed with a pressure washer or stripper product such as the Paint Panther Paint and Varnish Remover What if straightening the boards just isn’t going to fix the issue? You might have to replace the warped boards altogether, in which case here’s a link to Bangkirai: 12 weeks exposure. 006 Bangkirai is optically suitable and a very popular choice of colour tone. Also oiled finishes although dry and ready to use after 24 – 48 hours continue to cure and get more durable for days and weeks following application. Covering will prevent the natural curing process from occurring and this is one of the reasons we do not recommend putting rugs over and oiled floor for the first month. If this is the first time you have oiled/used a particular product it is best to patch test a small area to see how much oil needs to be applied for it to soak into the wood.